Now install the tank posts and front chassis brace. I use a 1/16 alle to push the lock nuts in to bottom the brace and those same needle nose on the other two.
Next is the plastic top plate that holds the bellcranks in place
This one is up to you but I prefer the IFMAR fuel 90 degree fitting on my tanks. To do this you will want to push or pull the internal fuel line to sit just against the back wall of the tank. This will make sure all fuel is drawn out of the lowest portion of the tank.
then leave roughly 1/4" of fuel line from the outside of tank and cut the excess off.
Now push the fitting long end first into the tank line. (A little motor spray in the tube or on the fitting will make this step easier)
I like to push the tank down onto the mounts and then hold the chassis on its side and screw the mounting screws (with washers) sideways to not drop the screw.
Bag A completed
