Montaggio losi 3.0 by casey peck - ..:: MonsterGarage.it ::.. n.1 in Italia per RC Monster & Truggy

**NIOREVO** · 07-03-2013, 16:04

First up is the steering link build up. Notice the shiney side of the rod end on the top one. (The lower one is displaying the matte finish and is the wrong side to pop from) This is the side you will want to pop the ball into. it will yeild the best / smoothest swivel action.

I use a a flat tooth set of needle nose to pop all of the ball in to the rod ends. This flat jaw style will not marr the aluminum or steel ball. Do this to both rod ends

Now with your 5/64 allen screw the threaded link into the rod end until it just starts to bottom out.

For the other side I will start the end in by hand and then insert the 5/64 allen into the ball to thread the rod on the rest of the way. (extreme force on the end with your fingers will eventually wear you out so I like to do things the easiet way

)

Strumenti della discussione
Visualizza la versione stampabile Invia questa pagina tramite email
Modalità di visualizzazione
Passa alla modalità lineare Passa al modo ibrido Modalità elencata

Discussioni simili
Discussione	Ha iniziato questa discussione	Forum	Risposte	Ultimo messaggio
montaggio retro su savy 25	Savage 1	Monster Truck HPI	4	20-01-2010 16:10
Montaggio frizione originale Revo 3.3	ROBERTO	Monster Nitro TRAXXAS	4	15-04-2009 09:00
montaggio carrozza razorback	revos	Monster Nitro TRAXXAS	11	15-12-2007 17:07
montaggio kit corone in metallo	monsterLST2	Motori	25	04-03-2007 21:02

07-03-2013, 16:04	#3
NIOREVO Super Moderatore Registrato dal: May 2005 residenza: Avellino Età : 48 Messaggi: 1,227 Potenza della reputazione: 34	First up is the steering link build up. Notice the shiney side of the rod end on the top one. (The lower one is displaying the matte finish and is the wrong side to pop from) This is the side you will want to pop the ball into. it will yeild the best / smoothest swivel action. I use a a flat tooth set of needle nose to pop all of the ball in to the rod ends. This flat jaw style will not marr the aluminum or steel ball. Do this to both rod ends Now with your 5/64 allen screw the threaded link into the rod end until it just starts to bottom out. For the other side I will start the end in by hand and then insert the 5/64 allen into the ball to thread the rod on the rest of the way. (extreme force on the end with your fingers will eventually wear you out so I like to do things the easiet way )